I've made a game. The rule of the game is to put the coin in to the holes in the platform. If you be succesful, the LEDs in the breadbord turn on.
There is two holes in the platform. I've insert conductive wires in them and the coin is covered with conductive fiber. So the switch is the coin in a whole. If the conductive fiber around the coin touches the wires inside the holes the lights turns on.
Each holes represent a LED. If you managed to put the coin in the longer distance hole, the red LED turns on and if you put it in the hole at the shorter distance the white light turns on. (Each wire windings inside the holes are connected to)
The circuit is in parallel connection.
The materials Ive used for this project are;
Breadbord
Energy Power
Red LED
White LED
2/ 220ohm Resistor
Wires under board
Breadboard
Schematic Diagram
Process
Preview
